1. Screw arm and arm extension together.
2. Turn base upside down, set washer into inset, and thread screw into base.
3. Attach arm to the base and tighten the screw with the Allen Wrench.
1. Use the Allen Wrench to loosen and remove the Mounting Bracket
2. Use the Mounting Bracket to help mark the wall at the desired height for the pilot holes. Mark the pilot holes with the pencil.
3. Use the drill to drill the pilot holes and a drill bit that is slightly less thick than the Wall Anchors.
4. Insert the wall achors.
5. Screw the Mounting Bracket onto the wall.
6. Attach Roll Holder onto Mounting Bracket and secure the holder with the Allen Wrench.
1. Remove adhesive sticker from the Roll Holder.
2. Do not attach Roll Holder to uneven surfaces, wallpaper, or concrete.
3. Firmly press the Roll Holder to the wall for 30 seconds.
4. To remove the Roll Holder, use a hair dryer to heat up adhesive, cut through the adhesive with dental floss, and rub off residue with your finger.